Toro Workman UTX - Driving the Machine

UsingtheCruiseControl
Inordertousecruisecontrol,yourseatbeltmustbe
fastened,andyouneedtobedrivingatthefollowing
groundspeedbasedonyourselectedgear:
•H(HighForward)gear—6km/h(4mph)or
greater
•L(LowForward)gear—3km/h(2mph)orgreater
1.MovethecruisecontrolswitchtotheONposition
(Figure71).
2.Whenyoureachthedesireddrivespeed,press
thecruisecontrolswitchuptoengage/setthe
cruisecontrol(Figure71).
Toincreasethecruisecontrolspeed,pressthe
switchupuntilyoureachthedesiredspeed
(Figure71).
Note:Pressthebutton1timetoincreasethe
groundspeedbyanincrementof1km/h(1
mph).
Todisengagecruisecontrol,presstheswitchto
thedown,OFFposition(Figure71).
Note:Whenyoupressthebrakepedal,the
cruisecontroldisengages.
g391453
Figure71
1.Setcruisecontrol/increase
cruisespeed
3.OFFpositon
2.ONposition
AdjustingtheGround
SpeedGovernor
1.Pressandholdthebutton(Figure72)foratleast
10seconds.
Thesetspeedwillblink.
2.Pressthebutton1timetoincreasetheground
speedbyanincrementof1km/h(1mph).
Note:Thedefaultmaximumspeedthatyou
canincreasetois40km/h(25mph).
Ifdoorsareinstalledonthemachine,the
maximumgroundspeedthatyoucanincrease
tois72km/h(45mph);theminimumis8km/h
(5mph).
g367226
Figure72
1.Button
StoppingtheMachine
Tostopthemachine,removeyourfootfromthe
acceleratorpedal,thenpressthebrakepedal.
ShuttingOfftheEngine
1.Stopthemachine.
2.ShiftthetransmissionlevertotheP(PARK)
position.
3.RotatethekeyswitchtotheOFFpositionand
removethekey.
66