e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
3-83
* This adjustment will have an effect only on Black and white mode printing.
(4) Enter adjustment mode [05]. Change the values for codes [8210 to 8212] or [8249 to 8254] to adjust the
threshold values for "Pure Gray" and "Pure Black" (to adjust the area to print only using the K toner).
• Adjust the value for [05] code corresponding to the print option to be applied (Apply to, PDL, Item,
Subcode (Image quality type)).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Apply to PDL [05] code Subcode Recommended value
Acceptable
value
range
Default
PCL6 05-8210 0/1/2/3 8 / 8 / 8 / 8
PS3 05-8252 0/1/2/3/4 8 / 8 / 8 / 8 / 8
Text
XPS 05-8249 0/1/2/3/4 8 / 8 / 8 / 8 / 8
PCL6 05-8211 0/1/2/3 1 / 1 / 1 / 8
PS3 05-8253 0/1/2/3/4 1 / 1 / 1 / 8 / 1
Graphics
XPS 05-8250 0/1/2/3/4 1 / 1 / 1 / 8 / 1
PCL6 05-8212 0/1/2/3 1 / 1 / 1 / 8
PS3 05-8254 0/1/2/3/4 1 / 1 / 1 / 8 / 1
Image
XPS 05-8251 0/1/2/3/4
Set a value smaller than
the default to decrease
the area to print only
using the K toner.
Set a value larger than
the default to increase the
area to print only using
the K toner.
1 to 255
1 / 1 / 1 / 8 / 1
* The subcode varies according to the Image quality type where the adjustment is performed. Refer to the
table below and set the subcode for the Image quality type to adjust.
Subcode Image Quality Type
0 General
1 Photograph
2 Presentation
3 Line Art
4 Color Profile
<Note> If the graphic and image options are changed, the adjustment may possibly cause the
unnatural hue of gradational and photo images, and the inadequate reproducibility of
gradations. Therefore, carefully perform the adjustment, while checking the printouts.
PCL6 PS3 Mac XPS
3. Printer-specific Adjustments
To Next Page
Loading...
Need help?
General
