Toshiba E-STUDIO5506AC - Page 210

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-74
3. Printer-specific Adjustments
* This adjustment will have an effect only on Black and white mode printing.
(5) Increase the values for codes [7315 to 7320] or [7309 to 7310] to adjust the gamma curve balance and
increase the Low/Medium density on Black and White mode printing.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Halftone).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Halftone [05] code Subcode
Recommended
value
Acceptable
value range
Default
PS3
(600dpi)
Smooth
05-7315
0/1/2
Set a value larger
than 128
0 to 255 128
Detail
05-7316
0/1/2
PS3
(1200dpi)
Smooth
05-7309
0/1/2
Detail
05-7310
0/1/2
PCL6
Smooth
05-7317
0/1/2
Detail
05-7318
0/1/2
XPS
Smooth
05-7319
0/1/2
Detail
05-7320
0/1/2
PDL Apply to [05] code Subcode
Recommended
value
Acceptable
value range
Default
PS3
Text
05-7360
0/1/2
Set a value larger
than 128
0 to 255 128
Graphic
05-7361
0/1/2
Image
05-7362
0/1/2
PCL6
Text
05-7363
0/1/2
Graphic
05-7364
0/1/2
Image
05-7365
0/1/2
XPS
Text
05-7366
0/1/2
Graphic
05-7367
0/1/2
Image
05-7368
0/1/2
* Set the value in increments of approximately 10, while checking the printouts until the optimum value is
obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted.
Subcode
Area where the density is adjusted
0
Low-density area
1
Medium-density area
2
High-density area
PCL6
PS3
Mac
XPS