Toshiba E-STUDIO5506AC - [Counter] Tab Page

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-8
2. Copier-specific Adjustments
After increasing the sharpness intensity, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(5) Select [05 ADJUSTMENT MODE] and change the values of the codes [7840], [7841] and [7842] to adjust
the reproduction level of the Text/Photo, User custom and Red seal color original modes.
The larger the value is, the clearer the reproduction of thin text will become.
Original mode
[05] Code
Recommended value
Acceptable value range
Default
Text/Photo 05-7840
Set a value larger than 5. 0 to 9 0
User custom 05-7841
Red seal color 05-7842
* Adjustment for the User custom setting is enabled in the Text/Photo mode base only.
* Set the value in increments of 1, while checking the copy image until the optimum value is obtained.
Set the value to “5” and check the copy image quality. If further image quality adjustment is necessary, set
the value to “6”. If further adjustment is necessary, increase the value step by step.
* If a value becomes too much larger, a photo area may become coarse.
* If “4” to “1” is set for the setting value, the text may become blurred.
* For the User custom mode, refer to “2.18 To Program Frequently Used Copy Settings (To Use Custom
Mode)”.
* The setting content of the default value “0” is the same as that for the value “5”.
Sin
ce "-25" is assigned to the center, the image quality
remains the same even if the indicator is changed from
"
-3" to "-4".
Setting value "103":
Default:
Soft
Sharp
+3
+50
+75
|
+1
0
+25
|
0
-25
0
|
-2
-75
-50
|
-4
-100
-100
|
+4
+75
+100
|
+2
+25
+50
|
-1
-50
-25
|
-3
-100
-75
|
Assigned adjustment
value of sharpness