Toshiba E-STUDIO5506AC - [Administration] Tab Page

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-9
2. Copier-specific Adjustments
(6) Select [05 ADJUSTMENT MODE]. Change the values for codes [7889 to 7892] to adjust the maximum
color density of the text.
Color to
adjust
[05] code
Recommended value
Acceptable
value range
Default
Y
(Yellow)
05-7889
Set a value larger than 5 to
increase the density.
Set a value smaller than 5 to
decrease the density.
0 to 10 5
M
(Magenta)
05-7890
C
(Cyan)
05-7891
K
(Black)
05-7892
* Set the value in increments of 1, while checking the copy image until the optimum value is obtained.
* This adjustment will be effective, only if the [TEXT/PHOTO] or [TEXT] mode is selected or the
[CUSTOM] mode based on the [TEXT/PHOTO] or [TEXT] mode is selected from among the original
mode options. Only the text areas (portions that are recognized as text) are adjusted in the
[TEXT/PHOTO] mode and [TEXT] mode. Only K color can be adjusted in the [TEXT] mode.
After adjusting the maximum color density of the text, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(7) Press [BASIC] on the Control Panel. Select “TEXT” from among the original mode options.
* To have “TEXT” selected from among the original mode options by default, refer to 2.18 To Program
Frequently Used Copy Settings (To Use Custom Mode).
After changing the value, make a copy and check the image quality.
If further image quality adjustments are necessary, reset all the values changed in steps (1) to (6) above to
the default one and then follow the next step.