Toshiba HX7+ ASD - Page 102

HX7+ ASD Installation and Operation Manual 93
OUT1 Off Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the opening of the OUT1 (A & C) output terminals by
the programmed value.
The delay may be increased to allow the devices that are connected to OUT1 to
respond.
Direct Access Number — F160
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT2 Off Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the opening of the OUT2 (A & C) output terminals by
the programmed value (see waveforms at
F160).
The delay may be increased to allow the devices that are connected to OUT2 to
respond.
Direct Access Number — F161
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
FL Off Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the opening of the FL output terminals by the
programmed value (see waveforms at
F160).
The delay may be increased to allow the devices that are connected to FL to
respond.
Direct Access Number — F162
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT4 Off Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the opening of the OUT4 output terminals by the
programmed value (see waveforms at
F160).
The delay may be increased to allow the devices that are connected to OUT4 to
respond.
Direct Access Number — F163
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT5 Off Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the opening of the OUT5 output terminals by the
programmed value (see waveforms at
F160).
The delay may be increased to allow the devices that are connected to OUT5 to
respond.
Direct Access Number — F164
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
F160 F164