110 HX7+ ASD Installation and Operation Manual
RX Torque Reference Setpoint #2
Program Torque Setting Setpoints RX
This parameter is used to set the gain and bias of the RX input terminal when
the RX terminal is used as the control input while operating in the Torque
Control mode.
This is accomplished by establishing an associated V/f output pattern for a
given RX input level.
See RX Speed Reference #1 for further information on this setting.
This parameter sets RX Torque Reference Setpoint #2 and is the output torque
value that is associated with setting of RX Speed Reference #2 while operating
in the Torque control mode.
Direct Access Number — F221
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Ye s
Minimum — -250.00
Maximum — 250.00
Units — %
F221 F221
To Next Page
Loading...
