Toshiba HX7+ ASD - Page 121

112 HX7+ ASD Installation and Operation Manual
RX2 Speed Frequency #1
Program Frequency Setting  Speed Reference Setpoints RX2
This parameter is used to set the gain and bias of the RX2 input terminal when
the RX2 terminal is used as the control input while operating in the Speed
Control mode.
See RX2 Speed Reference #1 (F222) for further information on this setting.
This parameter sets RX2 Speed Frequency #1 and is the frequency that is
associated with the setting of RX2 Speed Reference #1 while operating in the
Speed Control mode.
Direct Access Number — F223
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Ye s
Minimum — -Max. Freq. (F011)
Maximum — Max. Freq. (F011)
Units — Hz
RX2 Speed Reference #2
Program Frequency Setting  Speed Reference Setpoints RX2
This parameter is used to set the gain and bias of the RX2 input terminal when
the RX2 terminal is used as the control input while operating in the Speed
Control mode or the Torque Control mode.
See RX2 Speed Reference #1 for further information on this setting when used
for Speed control or Torque control.
This parameter sets the RX2 input level that is associated with RX2 Speed
Frequency #2 while operating in the Speed control mode or is associated with
the RX2 Torque Reference Setpoint #2 while operating in the Torque control
mode.
Direct Access Number — F224
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Ye s
Minimum — -100.0
Maximum — 100.0
Units — %
RX2 Speed Frequency #2
Program Frequency Setting  Speed Reference Setpoints RX2
This parameter is used to set the gain and bias of the RX2 input terminal when
the RX2 terminal is used as the control input while operating in the Speed
Control mode.
See RX2 Speed Reference #1 for further information on this setting when used
for Speed control.
This parameter sets RX2 Speed Frequency #2 and is the frequency that is
associated with the setting of RX2 Speed Reference #2 while operating in the
Speed Control mode.
Direct Access Number — F225
Parameter Type — Numerical
Factory Default — 80.00
Changeable During Run — Ye s
Minimum — -Max. Freq. (F011)
Maximum — Max. Freq. (F011)
Units — Hz
RX2 Torque Reference Setpoint #1
Program Torque Setting  Setpoints RX2
This parameter is used to set the gain and bias of the RX2 input terminal when
the RX2 terminal is used as the control input while operating in the Torque
Control mode.
This is accomplished by establishing an associated V/f output pattern for a
given RX2 input level.
See RX2 Speed Reference #1 for further information on this setting.
This parameter sets RX2 Torque Reference Setpoint #1 and is the output
torque value that is associated with the setting of RX2 Speed Reference #1
while operating in the Torque control mode.
Direct Access Number — F226
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — -250.00
Maximum — 250.00
Units — %
F223 F226