HX7+ ASD Installation and Operation Manual 185
RS232/RS485 Communications Time-Out Action
Program Communication Communication Settings
This parameter plays a role in the setup of the communications network by
determining the action to be taken in the event of a time-out (Time-Out
Action).
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or
modifies the parameter settings of the drive.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Settings:
0 — No Action
1 — Alarm
2 — Trip
Direct Access Number — F804
Parameter Type — Selection List
Factory Default — Trip
Changeable During Run — Ye s
Communication Interval
Program Communication Communication Settings
This parameter sets the Common Serial response delay time.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Direct Access Number — F805
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — 0.00
Maximum — 2.00
Units — Seconds
TTL Master Output
Program Communication Communication Settings
In a master/follower configuration, this setting determines the output parameter
of the master ASD that will be used to control the applicable follower ASDs.
Note: Select No Follower if F826 is configured as a Master Output
controller. Otherwise, a keypad failure will result.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Settings:
0 — No Follower (normal operation)
1 — Frequency Reference
2 — Output Command Frequency
3 — Torque Command
4 — Output Torque Command
Direct Access Number — F806
Parameter Type — Selection List
Factory Default — No Follower (normal
operation)
Changeable During Run — Ye s
F804 F806
To Next Page
Loading...
