194 HX7+ ASD Installation and Operation Manual
Table 16. Discrete Output Terminal Assignment Selections.
Function Function
0 Lower Limit (LL) 31 Ready for Operation (including ST and RUN)
1 Upper Limit (UL) 32 Ready for Operation
2 Low (speed specified at F100) 33 POFF Alarm (poor control power supply)
3 RCH (Acc/Dec completion) 34 System Consistent Sequence (BR: brake release)
4 RCH (speed specified at F101) 35 Alarm Active
5 Fault FL (all) 36 Forward Speed Limit (torque control)
6 Fault FL (except EF or OCL) 37 Reverse Speed Limit (torque control)
7 Over-Current Alarm 38 ASD Healthy Output
8 ASD Overload Alarm 39 Abnormal Communication Alarm 2 (internal cause)
9 Motor Alarm 40 Error Code Output 1 (6-bit error output)
10 Over-Heat Alarm 41 Error Code Output 2 (6-bit error output)
11 Over-Voltage Alarm 42 Error Code Output 3 (6-bit error output)
12 DC Voltage Low Alarm 43 Error Code Output 4 (6-bit error output)
13 Low-current Alarm 44 Error Code Output 5 (6-bit error output)
14 Over-Torque Alarm 45 Error Code Output 6 (6-bit error output)
15 Braking Resistor Overload Alarm 46 Designated Data Output 1 (7-bit transmission output)
16 Emergency Off Active 47 Designated Data Output 2 (7-bit transmission output)
17 Retry Active 48 Designated Data Output 3 (7-bit transmission output)
18 Pattern Operation Switching Output 49 Designated Data Output 4 (7-bit transmission output)
19 PID Deviation Limit 50 Designated Data Output 5 (7-bit transmission output)
20 Start/Stop 51 Designated Data Output 6 (7-bit transmission output)
21
Serious Fault (OCA, OCL, EF, Lost Phase, Short
Circuit, or Abnormal Output)
52 Designated Data Output 7 (7-bit transmission output)
22 Light Fault (OL, OC1, 2, 3, OP) 53 Light Load Detection Signal
23 Bypass Output #1 54 Heavy Load Detection Signal
24 Bypass Output #2 55 Positive Torque Limit
25 Fan On/Off 56 Negative Torque Limit
26 Jog Active 57 External Rush Suppression Relay Output
27 Terminal Board Operation Command Mode 58 Over Travel
28 Total-Operation-Hours Alarm 59 Positioning Completion
29 Abnormal Communication Alarm (external cause) 60 Earth Fault Alarm
30 Forward/Reverse Operation 61 Low Output Disable Alarm
To Next Page
Loading...
