Toshiba PORTEGE Z930 - H;W (Hardware) Initial Information Setting Tool; Heatrun Test Program

Tests and Diagnostics
PORTÉGÉ Z930/Satellite Z930 Series Maintenance Manual (960-887) [CONFIDENTIAL] 3-9
 A USB cable (USB test)
 LAN wraparound connector (LAN test)
 RGB wraparound connector (Expansion test)
 Module cable and RJ11 connector checker (Modem test)
 Headphones (Sound test)
 A microphone (Sound test)
 A PC for wraparound test (Wireless LAN test/Bluetooth test/IEEE1394 test)
 PC card wraparound connector (Expansion test) [Not necessary for this model)
3.1.2 H/W (Hardware) initial information setting tool
The H/W initial information setting tool consists of the following programs.
 Initial configuration
 DMI information save
 DMI information recovery
 System configuration display
 E2PROM test (MAC/GUID/DMI)
You will need the following equipment to perform some of the programs.
 The Diagnostics Disk (Main T&D)
3.1.3 Heatrun test program
The heatrun test starts automatically after the selection.
You will need the following equipment to perform this program.
 The Diagnostics Disk (Main T&D)