Troubleshooting Procedures
PORTÉGÉ Z930/Satellite Z930 Series Maintenance Manual (960-887) [CONFIDENTIAL] 2-53
2.13 Memory media (SD Card) Slot Troubleshooting
This section describes how to determine if the computer's Memory media (SD Card)
functions are functioning properly. Perform the steps below starting with Procedure 1 and
continuing with the other procedures as required.
Procedure 1: Check on Windows OS
Procedure 2: Connector Check and Replacement Check
2.13.1 Procedure 1 Check on Windows OS
Insert a SD Card (SD memory card/Multimedia card) into the slot. Check if the installed
Windows recognizes automatically the SD Card and the data in the SD Card can be read.
If the card is not recognized or data are not red, go to Procedure 2.
2.13.2 Procedure 2 Connector Check and Replacement Check
The SD Card is connected to IS2130 on the System board.
SD Card supports SD memory card/Multimedia card.
As the connection may be defective, disassemble the computer and check each connection.
If the problem still occurs, go to Check 1.
Check 1 SD Card may be disconnected. Make sure the SD Card is firmly inserted to IS2130.
If not, insert it firmly. If the SD Card is still not functioning properly, perform
Check 2.
Check 2 SD Card may be faulty. Replace it with a new one following the step in Chapter 4
Replacement Procedures. If the problem continues, perform Check 3.
Check 3 System board may be faulty. Replace it with a new one following the step in
Chapter 4 Replacement Procedures.
To Next Page
Loading...
