4 Replacement Procedures
4-64 [CONFIDENTIAL] PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887)
4.15 Wireless LAN antenna/3G antenna/Camera module
Removing the Wireless LAN antenna/Bluetooth antenna/3G antenna
To remove the wireless LAN antenna/Bluetooth antenna/3G antenna, follow the steps below
and refer to Figure 4-30 and 4-31.
1. Peel off the insulator (INSU SQUARE) and turn up the insulators (INSU ANT LCD
HLD).
2. Peel off the wireless LAN antennas/3G antennas from the LCD cover.
3. Disconnect the camera harness from the connector on the camera module.
4. Peel off the camera module from the slot of the LCD cover.
5. Peel off the camera harness from the LCD cover.
NOTE: Do not reuse the removed wireless LAN antennas, 3G antennas, camera module
and camera harness. Be sure to use new wireless LAN antennas, 3G antennas,
camera module and camera harness.
To Next Page
Loading...
