Toshiba PORTEGE Z930 - Installing the Touch Pad;Fingerprint Sensor Board

4 Replacement Procedures
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887) [CONFIDENTIAL] 4-45
Installing the Touch pad/Fingerprint sensor board
To install the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-18 to 4-21.
1. Slide the TP board to the hole of the cover assembly and secure it with the following
screws.
 M23B S-THIN HEAD 2
2. Stick the insulator (INSU SQUARE) to a new fingerprint sensor board in place.
NOTE: Stick the insulator (INSU SQUARE) to the fingerprint sensor board in place as
shown in the figure below.