4 Replacement Procedures
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887) [CONFIDENTIAL] 4-59
Installing the LCD
To install the LCD, follow the steps below and refer to Figure 4-26 to 4-29.
NOTE: When replacing the LCD with a new one, stick the INSU LCD BLIND to the
LCD in place.
1. Connect the LCD harness to the connector on the LCD and stick the tub portion of
the LCD harness to the LCD.
2. Set the LCD to the LCD cover and arrange the LCD harness in place.
NOTE: When the both-sided tape on the LCD cover is peeled, stick the both-sided tape
on the LCD cover in place.
When replacing the LCD cover with a new one, peel off the separator of the
both-sided tape on the LCD cover and stick the LCD to the LCD cover.
To Next Page
Loading...
