4 Replacement Procedures
4-40 [CONFIDENTIAL] PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887)
Installing the Speaker
To install the speaker, follow the steps below and refer to Figure 4-17.
1. Set the speaker to the slots of the cover assembly.
2. Turn up the insulators (INSU SPK HNS HLD and INSU COV TPAD) and arrange
the speaker harness in place.
NOTE: When replacing the cover assembly with a new one, peel off the separators of the
INSU SPK HNS HLD and INSU COV TPAD and fix the speaker harness with the
insulators.
3. Close the insulators (INSU SPK HNS HLD and INSU COV TPAD).
4. Stick the glass tapes in place.
To Next Page
Loading...
