Tests and Diagnostics
3-146 [CONFIDENTIAL]) PORTÉGÉ Z930/Satellite Z930 Series Maintenance Manual (960-887)
3.35.2 How to start T&D
3.35.2.1 Diagnostics main menu
Set the TOSHIBA Test & Diagnostic CD to the ODD drive and turn the power of the system
on.
If you select Freedos on the BOOT selection screen then the test program is loaded and the
following test selection screen is displayed. (Refer to section 4.2.2 for details.)
Use the Up or Down cursor key to select your desired item and press the [Enter] key.
If you select [1] on the above screen, the test menu for selecting each test is displayed. In
addition, items
[5] - [7] indicate the tasks to be supported by this T&D.
Note: Pressing the [Esc] key or selecting [0] on the screen terminates this test program
and the FreeDOS command prompt appears.
To Next Page
Loading...
