Toshiba PORTEGE Z930 - 4.7 DC fan

4 Replacement Procedures
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887) [CONFIDENTIAL] 4-29
4.7 DC fan
Removing the DC fan
To remove the DC fan, follow the steps below and refer to Figure 4-13.
1. Disconnect the fan harness from the connector CN3380 on the system board.
2. Remove the following screws securing the DC fan.
 M2.55C FLAT HEAD 2
3. Remove the DC fan from the slot.
Figure 4-13 Removing the DC fan
CN3380
DC fan
M2.5x5C FLAT HEAD
Fan harness