Toshiba PORTEGE Z930 - Installing the RTC Battery;Ln Board;3 G Card

4 Replacement Procedures
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887) [CONFIDENTIAL] 4-27
Installing the RTC battery/LN board/3G card
To install the RTC battery/LN board/3G card, follow the steps below and refer to Figure 4-8
to 4-12.
1. Connect the 3G card to the connector CN2610 on the LN board.
2. Set the LN board to the cover assembly and secure it with the following screws.
 M23B S-THIN HEAD 3
NOTE: When replacing the LN board with a new one, stick the insulators (INSU HNS
HOLD and INSU HNS BH R) and gasket (WiMAX model only) to the LN board
in place.
WiMAX model only