Toshiba PORTEGE Z930 - Procedure 3 Connection Check; Ptv Output

Troubleshooting Procedures
PORTÉGÉ Z930/Satellite Z930 Series Maintenance Manual (960-887) [CONFIDENTIAL] 2-19
 PTV output
Error code Meaning
D0h
PTV voltage is over 1.26V.
D1h
PTV voltage is under 0.89V when the computer is powered on.
D2h
PTV voltage is under 0.89V when the computer is booting up.
 Miscellaneous
Error code Meaning
F0h The sub clock does not oscillate.
Check 2 In the case of error code 10h or 12h:
 Make sure the AC adapter and AC power cord are firmly plugged into the DC
IN 19 V socket and wall outlet. If the cables are connected firmly, go to the
following step.
 Connect a new AC adapter and AC power cord. If the problem still occurs, go
to Procedure 5.
Check 3 In the case of error code 21h:
 Go to Procedure 3.
Check 4 For any other errors, go to Procedure 5.
2.3.3 Procedure 3 Connection Check
The wiring diagram related to the power supply is shown below: