4 Replacement Procedures
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887) [CONFIDENTIAL] 4-49
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-22.
1. Stick a new insulator (INSU KB) on the cover assembly.
2. Peel off the separator of the insulator (INSU KB).
NOTE: When sticking an INSU KB to COVER ASSY, refer to the following figure.
3. Stick a new keyboard on the insulator (INSU KB).
NOTE: Arrange the KB flexible cable and KB BL flexible cable as shown in the figure
below.
To Next Page
Loading...
