Toshiba PORTEGE Z930 - Page 300

4 Replacement Procedures
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887) [CONFIDENTIAL] 4-17
4. Set the base assembly to the cover assembly and secure them with the following
screws.
 M2.54B TORX screw 1 (Described as “4T” in the Figure 4-4)
 M2.54B FLAT HEAD screw 11 (Described as “4” in the Figure 4-4)
 M2.510B FLAT HEAD screw 2 (Described as “10” in the Figure 4-4)
NOTE: Set the base assembly as shown in the figure below.
5. Stick the bottom cap in place.
Base assembly
1
2