Station Apparatus
3000-series Telephone Settings
8-16 Strata CTX I&M 10/02
Telephone Programming Mode A
The 3000-series telephones enable you to set a number of features directly from the phone,
including: Call Waiting Tone (On/Off), Flex Key, Msg Key, LCD contrast, Speakerphone/
Microphone Room Noise Sensitivity (On/Off), and Country settings. “Telephone Programming
Mode A” programs settings on a ROM chip inside the telephone.
Note Some of the procedures use Feature Buttons (FB1, FB2, etc.). When your telephone is in
Programming Mode, the flexible buttons are numbered as Feature Buttons, as shown in
Figures 8-12 and 8-13.
➤ To place your telephone in Programming Mode A
➤ Press ++++ROG simultaneously. The LCD displays “DKT PROGRAM MODE” and
“SELECT=”. Your phone will not ring if it receives a call while in Programming Mode.
➤ To exit from Programming Mode A
➤ Go Off- and On-hook or wait for 30 seconds for Programming Mode to automatically time out.
Telephone Program Option Reset
This function resets all Programming Mode A option settings to their default setting.
1. Press
++++ROG (simultaneously).
2. Press
9RO ▲ + 0VJ (0VJ LED On means reset is set to activate)
3. Press
+ROG to activate reset.
4. Go off-hook, then on-hook to exit the program mode.
Dial Pad and Button Beeps
Digital telephones can emit a “beep” sound whenever a dial pad or feature button is pressed. The
“beeps” are On by default. Follow these steps to turn the “beeps” On or Off on 3000-series DKTs.
1. Press
++++ROG (simultaneously).
2. Press
.
3. Press Feature Button 1 (FB1) to toggle On/Off.
FB1, LED On: buttons beep.
FB1, LED Off: buttons do not beep.
4. Press
+ROG to set the option.
5. You must also go off-hook, then on-hook to exit the program mode.
To Next Page
Loading...
