Toshiba Strata CTX100 - Step 11: Attach and Route PCB Cables

Strata CTX100 Installation
Installing the CTX100 Cabinet
2-22 Strata CTX I&M 10/02
Step 11: Attach and Route PCB Cables
1. Determine the direction that you want the cables to exit the cabinet(s) from the following:
• Single Direction Cable Routing – Cabling from the Expansion Cabinet can run through the
Base Cabinet and exit from the Base Cabinet (see Figure 2-19).
Figure 2-19 Single Direction Cable Routing
• Opposite Direction Cable Routing – Cabling from the Expansion Cabinet can run through
the right and left sides (see Figure 2-20).
Figure 2-20 Opposite Direction Cable Routing
AMDS
(Optional)
V.34 Modem
One per system to provide
33.6kbps maximum modem for
WinAdmin.
ACTU
BSIS
(Optional)
Serial interface unit (same unit used for
CTX670).
Provides four RS-232 serial ports
(SMDR, SMDI)
ACTU
ABCS
(Optional)
Battery Charger Circuit.
One per Power Supply for
connection of Reserve Power
(requires ABTC-3M Battery Cable).
APSU112A
Table 2-2 CTX100 Cabinet and Processor Components (continued)
PCB Provides Comments Installs On
6006
Power SupplyPower Supply
AC Cord and
Battery Cables
6007
Power SupplyPower Supply
AC Cord and
Battery Cables