Station Apparatus
Tilt Stands and Wall Mounting
Strata CTX I&M 10/02 8-25
Station Apparatus
Tilt Stand for DKT + 2 ADMs
Use Tilt Stand models “BTSA” for DKTs with one or two ADMs.
➤ To attach a digital telephone with two ADMs to a Tilt Stand
1. Complete the steps under “To install DADMs” on page 8-20.
2. Make sure bottom phone jack is plugged in.
3. Remove Tilt Stand from Tilt Stand Base (see Figure 8-21).
4. Place the spacers on the outer holes, as shown (see Figure 8-22).
5. Attach Tilt Stand to bottom of DKT with screws.
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the “bottom
pegs” fit into the holder. Adjust Tilt Stand so that the “top pegs” fit into the top Tilt Stand Base
holes. Do this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees). See
Figure 8-23.
8. Push in the Lock Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt
Stand.
Figure 8-22 Attach Tilt Stands to DKT with Two ADMs
5609
DKT
1 ADM
(A)
Spacer
2 ADM
1 ADM
2 ADM
DKT
DKT
DKT
DKT
1 ADM
2 ADM
1 ADM
2 ADM
DKT DKT
DKT
(A)
Spacer
2 ADM
1 ADM
1 ADM
2 ADM
1 ADM
2 ADM
2 ADMs + 1 DKT
Put in three screws in the
positions marked “DKT.”
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
Put in three screws in the
positions marked “2ADM.”
ADMs DKT
To Next Page
Loading...
