Toshiba Strata CTX100 - Page 289

Station Apparatus
Tilt Stands and Wall Mounting
Strata CTX I&M 10/02 8-27
Station Apparatus
5. Connect the phone to the wall modular
connector with a cord approximately four inches
long (available at most telephone supply
companies).
6. Route the cord into the hollow portion of the
base.
7. Mount the phone on the wall mounting modular
connector plate.
➤ To wall mount DKT3001 or DKT2001
digital SLTs
1. Loosen the screws, and remove the
telephone base.
2. Using a suitable cutter, remove the
handset hanger from the base.
3. Insert the handset hanger in the slot on
the front of the phone. The hanger fits in
the notch on the handset cradle.
4. Rotate the telephone base 180 degrees
and secure it to the telephone with its
four screws.
5. Connect the phone to the wall modular
connector with a cord approximately
four inches long (available at most
telephone supply companies).
6. Route the cord into the hollow portion
of the base.
7. Mount the phone on the wall mounting
modular connector plate.
For instructions for installing and
programming the DKT2001, see “Digital Single Line Telephone (DKT2001 only)” on page 8-47.
Figure 8-25 Wall Mounting Base Rotation
1480
Handset
Hanger
1479
Figure 8-26 Handset
Handset Hanger
3633
Figure 8-27 Removing the Telephone Base