Toshiba Strata CTX100 - Page 345

Index
F ~ L
Strata CTX I&M 10/02 IN-3
Index
subassembly (RCMS), 1-16
EMC ferrite core requirement, 5-20
ethernet LAN, 2-21
ethernet LAN interface
CTX100, 1-3
expanded system, 1-7
expansion cabinets, 1-3, 1-8, 3-33
installation, 3-6
external
page, 1-12
page zones, 1-12
external page, 9-10
BGM, 9-10
external ringer, 9-17
external speaker unit (HESB), 9-17
F
flash memory, 1-3, 1-6
four-circuit
loop start CO line interface unit, 4-16
functional block diagram, 1-18
G
ground/loop start interface CO line interface
unit, 1-16
grounding terminal screws, 5-17
H
handset OCA stations, 1-12
headset upgrade, 8-7, 8-38, 9-18
HESB, 9-17
amplified speaker
installation, 9-21
installation test, 9-22
loud ringing bell, 9-17
installation for DKT, 9-17
test, 9-21
talkback amplified speaker
installation, 9-23
HHEU, 8-38
hunt groups, 1-12
I
installation, 8-31
base cabinet, 3-6
BPCI, 8-10
DADM, 8-20
DPFT, 9-26
ISDN
basic rate interface unit (RBSU)
subassembly (RSSS), 1-16
BRI, 1-10
RBSU/RBSS
cabinet installation, 5-16
call monitor, 5-24
installation, 5-13
interface unit, 5-11
LED indications, 5-16
LEDs and connectors, 5-18
monitor jack, 5-17
option switches, jumpers, and
connectors, 5-14
overview, 5-11
passive bus configurations, 5-23
premise wiring guidelines, 5-17, 5-18
RBUU
installation, 5-24
RBUU/RBUS
interface unit, 5-27
LED indications, 5-26
location of LEDs and connectors, 5-26
RPTU
testing and troubleshooting, 5-11
performance monitoring, 5-37
PRI, 1-10
RPTU overview, 5-3
RBSU/RBSS, 5-20, 5-21
RBSU/RBSS premise wiring guidelines, 5-17
RPTU testing and troubleshooting, 5-31
timing and synchronization, 5-32, 5-33
ISDN
BRI
RBSS PCB installation, 5-15
RBSU/RBSS
capacity and cabinet slot
information, 5-12
PS-1 backup power option, 5-12
REBS PCB
installation, 5-15
R40S PCB installation, 5-15
L
large-scale intregrated circuit, 1-2, 1-6
license control, 1-4, 1-7
line buttons, 1-11
line capacities, 1-10