3 Tests and Diagnostics 3.31 SETUP
3-100 TECRA M3 Maintenance Manual (960-507)
(c) Dynamic CPU Frequency mode
Use this option to choose a setting from the followings.
Dynamically Switchable
Enables Intel SpeedStep technology. When the computer is in
use, the CPU power consumption and clock speed are
automatically switched when necessary. (Default)
Always High Disables Intel SpeedStep technology and always runs the
processor at its fastest speed.
Always Low Disables Intel SpeedStep technology and always runs the
processor at low power consumption and low speed.
(d) Execute-Disable Bit Capability
Selects the function to reports whether the CPU Execute-Disable Bit is available or
not to OS. When the CMOS is damaged, the default is Available. When Home is
pressed, the setting is not changed and the setting is kept.
Available Reports that the function is available.
Not Available Reports that the function is not available.
(e) Auto Power On
Use this option to set a time and date for automatic power on and enable or disable
the ring indicator feature. Alarm Date Option appears only when Alarm Time is
enabled.
*Only for LAN Model
Alarm Time is set in the sequence of hours and minutes. Seconds cannot be
changed. Alarm Date Option is set in the sequence of month and day. If Alarm
Date is set to Disabled, the computer will be powered on at the same time every
day. Press ? to move the cursor to the right and ? to move the cursor to the left
when you set the date and time.
NOTE: Do not remove the AC adapter and battery pack at the same time when you use
this feature. If you do so, data saved by the resume function will be lost. You
must also reset this option.
Alarm Time = 00:00:00
Alarm Date Option = Disabled
Wake-up on LAN = Disabled*
To Next Page
Loading...
