3.31 SETUP 3 Tests and Diagnostics
TECRA M3 Maintenance Manual (960-507) 3-105
Right Alt + Right Shift
Left Alt + Caps Lock
*If these selections are made, you cannot warm boot the system by pressing Ctrl + Alt
+ Del.
Disabled Disables the feature. (Default)
(c) Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
ECP Sets the port mode to Extended Capabilities Port (ECP). For most
printers, the port should be set to ECP. (Default)
Std. Bi-Direct.
This setting should be used with some other parallel devices.
(d) Hard Disk Mode
Use this item to select the hard disk mode.
Enhanced IDE Select this mode when using an operating system that
(Normal) supports Enhanced IDE. (Default)
Standard IDE Select this mode when using an operating system that does
not support Enhanced IDE.
NOTE: Formats for Enhanced IDE and Standard IDE are different, so if you change the
setting, you will have to reformat the hard disk for the appropriate setting.
15. Legacy Emulation.
(a) USB KB/Mouse Legacy Emulation.
Use this option to enable or disable USB KB/Mouse Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse and
keyboard by setting the USB KB/Mouse Legacy Emulation item to Enabled.
Enabled USB Legacy Support can be used. (Default)
Disabled USB Legacy Support cannot be used.
(b) USB-FDD Legacy Emulation.
Use this option to enable or disable USB-FDD Legacy Emulation.
Enabled USB Legacy Support can be used. (Default)
Disabled USB Legacy Support cannot be used.
To Next Page
Loading...
