4 Replacement Procedures 4.24 Microphone / Wireless LAN antenna / Bluetooth antenna
4-80 TECRA M3 Maintenance Manual (960-507)
Installing the Microphone / Wireless LAN antenna / Bluetooth antenna
To install the microphone / wireless LAN antenna / Bluetooth antenna, follow the steps below and
refer to Figure 4-52 and 4-53.
1. Set the microphone into the slot while passing through the cable in place.
2. Stick the five acetate tapes.
3. Stick the wireless LAN antennas and Bluetooth antenna.
4. Pass the wireless LAN antenna cables and Bluetooth antenna cable through the hole
and set them in place.
5. Secure the wireless LAN antenna cables and Bluetooth antenna cable with the ten
acetate tapes.
6. Stick the aluminum tape.
7. Install the hinge cap (right).
To Next Page
Loading...
