4.25 Hinge 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-85
Installing the Hinge
To install the hinge, follow the steps below and refer to Figure 4-54 to 4-57.
1. Pass the LCD cable through the hole.
2. Set the both sides hinges and secure them with the following screws (on the back).
? M2.5?6 Tapping screw ?2
3. Secure both the hinges with the following screws.
? M2.5?5B FLAT HEAD screw ?2
4. Secure the following screws and stick the mask seals.
? M2.5?2.8B FLAT HEAD screw ?2
5. Install the hinge cap.
6. Set the LCD cable holder and secure it with the following screw.
? M2.5?4B FLAT HEAD screw ?1
To Next Page
Loading...
