4.26 Fluorescent Lamp 4 Replacement Procedure
TECRA M3 Maintenance Manual (960-507) 4-101
Removing the PCB-assembly cell
1. Remove the PCB- assembly cell from the backlight unit, as shown in Figure 4-73.
2. Completely remove the double-sided tape remaining on the reverse side of the cell.
CAUTION: (1) Remove the tape slowly not to break the cell. The cell and frame are
glued by double-sided adhesive tape (as shown in Figure 4-73).
(2) Be careful not to remove the light shielding tapes from the upper, left
and right sides of the cell.
Figure 4-73 Replacing TMD fluorescent lamp (XGA) (5)
Double-sided tape
To Next Page
Loading...
