4.26 Fluorescent Lamp 4 Replacement Procedure
TECRA M3 Maintenance Manual (960-507) 4-105
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
CAUTION: (1) The GND-CU and lamp reflector on the left-hand side must not go
beyond the edges of the bezel.
(2) Be careful not to damage the cables and TAB.
(3) The bezel latches must be engaged (there are three latches).
Figure 4-77 Replacing TMD fluorescent lamp (XGA) (9)
Next, fit the bezel’s edge
close to the TAB.
Engage the three latches.
First, fit the bezel’s edge
close to the lamp. Use care
not to damage the FL cable.
The fold of lamp reflector must not
go beyond the bezel’s edge.
The fold of
GND-CU must
not go beyond
the bezel’s
To Next Page
Loading...
