4 Replacement Procedure 4.26 Fluorescent Lamp
4-106 TECRA M3 Maintenance Manual (960-507)
Fasten screws of the PCB and bezel
1. Fasten four screws on the left.
2. Fasten four screws on the right.
CAUTION: (1) Fasten the screws in the orders shown in Figure 4-78. No loose fastening
is allowed.
(2) The tightening torque must not exceed 0.147N ?m (1.5kgf?cm) for all the
eight screws.
(3) For the Philips screwdrivers, use an insert bit of point size 0.
Figure 4-78 Replacing TMD fluorescent lamp (XGA) (10)
Insulation sheet
To Next Page
Loading...
