3.
System Configuration Unit and Module
38
Terminal Block Unit UTBA1
UTBA1 specifications
Item Specification
Model name UTBA1
Form of mounting Exclusively for perpendicular mounting on the DIN rail
(fixed in place with M4 screws)
Number of modules that can be mounted Up to 2 PI/O modules
Compatible modules SAI01, SAI06*, STC01, SAO01, SAO06*, SPI01,
SPI06*, SPO01
Compatible option boards FIVC11, FIVC12 (only SAI01 module can be used)
Compatible short bars FSBR2
Cold contact point compensation for use
with thermocouples
Built in (valid when STC01 module is used)
External wire terminal blocks 2 removable type terminal blocks (of 21 terminals per
block M3.5 screws)
Matching external wire size 1.25 mm
2
or less
External power supply
24 Vdc
10%, ripple 5% or less (for SPI01, SPO01
modules)
Maximum current in I/O bus 24 Vdc-2.2 A (total PI/O modules current consumption)
Accessories 1 I/O bus cable ZCS005A0701
1 blank cover FSCV1
Ability of insulation to withstand voltage 500 Vac for 1 minute (between modules, between
external and internal signals)
External dimensions
80 W
240 H
77 D mm (unit by itself, excluding
protrusions)
80 W
240 H
120 D mm (with PI/O module mounted,
excluding protrusions)
Weight 750 g or less (this unit by itself)
* Used as a single configuration