Safety Precautions
iv
3. Safety Precautions for Part Replacement
WARNING
Ensure to stop fans:
When replacing fan unit, make sure to stop the fan by switching off the fan unit at the distribution
panel (or circuit breaker), before detaching the power cord. Failure to do so may result in electric
shock or injury due to the fan blades in motion.
4. Safety Precautions for Daily Use
WARNING
Check specifications:
Before using the equipment, make sure that the capacity, frequency, voltage and regulation of the
power supply meet the specifications of the equipment. In case they don't, the equipment may not
only work adequately but may suffer a breakdown or cause overheat that may result in fire.
Turn off power in the event of a problem:
If the temperature in or around the equipment becomes abnormally high or an unusual fault occurs
in the equipment, stop using it and turn off power, then contact your Toshiba representative. If left
alone, overheat may result in fire.
Avoid touching hot components:
Some components inside the modules become very hot after the power is turned on. To avoid burns,
do not touch them.
CAUTION
Do not touch components:
Do not touch pins, connectors or soldered surfaces in modules with any part of your body. Static
electricity may damage IC's or LSI's and cause equipment to fail. Also the pointed end of component
lead may hurt your body.
Do not disassemble the equipment:
Do not disassemble or modify the equipment or modules. Doing so may lesson equipment safety or
result in equipment malfunction or failure.
To Next Page
Loading...
Need help?
General
