E6581386
E-44
5
[How to select parameters]
Select the desired parameters as parameters 1 to 32 (~). Note that parameters should be specified
by communication number. For communication numbers, refer to Table of parameters.
In the quick mode, only parameters registered as parameters 1 to 32 are displayed in order of registration.
By default, parameters are set as shown in the table below.
[Parameter setting]
Title Function Adjustment range Default setting
Quick registration parameter 1 ~ ()
Quick registration parameter 2 ~ ()
Quick registration parameter 3 ~ ()
Quick registration parameter 4 ~ ()
Quick registration parameter 5 ~ ()
Quick registration parameter 6 ~ ()
Quick registration parameter 7 ~ ()
~
Quick registration parameter 8
~
Quick registration parameter 31
~
Quick registration parameter 32 ~ ()
Note: If any number other than communication numbers is specified, it is
regarded as (no function assigned).
Continuous : Disabled
Shortcut key function (=)
This function allows you to register, in a shortcut list, parameters whose settings need to be changed frequently so
that you can read them out easily in a single operation.
The shortcut is usable in the frequency monitor mode only.
[Operation]
Set the parameter to , read out the setting of the parameter you want to register, and press and hold
down the EASY key for 2 sec. or more. The registration of the parameter in a shortcut list has been completed.
To read out the parameter, just press the EASY key.
To Next Page
Loading...
Need help?
General
