Toshiba TOSVERT VF-PS1 - Page 160

E6581386
F-44
6
[Parameter setting]
Title Function Adjustment range Default setting
 Acceleration time 2 [Note]~ sec. According to model
 Deceleration time 2 [Note]~ sec. According to model
 Panel acceleration/deceleration selection
: Acceleration/deceleration 1
: Acceleration/deceleration 2

Note: The minimum setting of acceleration and deceleration times have been set respectively at 0.1 sec. by default,
but they can be changed within a range of 0.01 sec. (setting range:0.01~600.0 sec.) by changing the setting
of the parameter  (default setting).  For details, refer to Section 5.20.
1) Selection using parameters
Time [s]
Output frequency [Hz]





0
Time [s]

=

=
Acceleration/deceleration time 1 is initially set as the default. Acceleration/deceleration time 2 can be selected by
changing the setting of the .
Enabled if = (operation panel input enabled).
2) Switching by frequencies - Automatically switching acc/dec times at certain frequencies
Title Function Adjustment range Default setting
 Acceleration/deceleration switching frequency ~ Hz 
(3) Deceleration at the gradient corresponding
to deceleration time

(4) Deceleration at the gradient corresponding
to deceleration time

(1) Acceleration at the gradient corresponding
to acceleration time

(2) Acceleration at the gradient corresponding
to acceleration time

(1) (2) (3) (4)


Time [s]0
Output frequenc
y
[
Hz
]
Set frequency