Toshiba TOSVERT VF-PS1 - Page 161

E6581386
F-45
6
3) Switching using external terminals - Switching the acceleration/deceleration time via external terminals
(3) Deceleration at the gradient corresponding
to deceleration time

(4) Deceleration at the gradient corresponding
to deceleration time 
(1) Acceleration at the gradient corresponding
to acceleration time

(2) Acceleration at the gradient corresponding
to acceleration time

Output frequency [Hz]
(1)
(2) (3) (4)
A
cceleration/deceleration
switching signal
Time [s]
0
 Setting parameters
a) Operating method: Terminal input
Set the command mode selection  to .
b) Use the S2 terminals for switching. (Instead, other terminals may be used.)
Title Function Adjustment range Setting value
 Input terminal function selection 6 (S2) ~
 (Acceleration/deceleration
switching signal 1)
 Acceleration/deceleration pattern
Acceleration/deceleration patterns can be selected individually, using the acceleration/deceleration 1 and 2
parameters.
1) Straight acceleration/deceleration
2) S-pattern acceleration/deceleration 1
3) S-pattern acceleration/deceleration 2
Title Function Adjustment range Default setting
 Acceleration/deceleration 1 pattern :Straight, :S-pattern 1, :S-pattern 2 
 Acceleration/deceleration 2 pattern :Straight, :S-pattern 1, :S-pattern 2 
1) Straight acceleration/deceleration
A general acceleration/deceleration pattern.
This pattern can usually be used.

Output frequency [Hz]

Maximum frequency

Time [s]
0