E6581386
H-8
8
(Continued)
Communication
No.
Default
setting
Item displayed Marking Unit (Panel)
Unit
(Communication)
FD85 COUNT1 1 1
FD86 COUNT2 1 1
FD52 PID result frequency 0.1Hz 0.01Hz
FE84
Synchronous speed frequency
command
0.1Hz 0.01Hz
Note 1: If any value other than the values in the above table is specified, the number “” is displayed.
Note 2: If a negative value of signed signal is specified, the negative sign “-” is displayed. When the negative sign “-”
is displayed, do not display "", "", "". When read through by communications device, the negative sign is
affixed only FE18~FE20, FE37 and FE38 values.
Note 3: Data set with FA65-FA79 is displayed.
For details, refer to Instruction Manual (E6581413) specified in Section 6.36.
Note 4: Unit of display is able to change depends on ~ setting.
Note 5: If monitor this item, operate a motor in automatic torque boost mode or vector control mod (=, , ,
or )
To Next Page
Loading...
