K-4
E6581386
11
2. Basic parameter [4/4] Sensorless vector/PG feedback control (●:Effective, -:Ineffective)
Title
Communi
cation
No.
Function Adjustment range
Minimum
setting unit
(Panel/Communi
cation)
Default
setting
Write during
running
Vector
control
PM
control
V/f Reference
0308 Dynamic braking resistance 0.5~1000Ω 0.1/0.1 *2 Disabled ●/● ● ● 5. 19
0309 Dynamic braking resistor capacity 0.01~600.0kW 0.01/0.01 *2 Disabled ●/● ● ● 5. 19
0007 Factory default setting
0: -
1:50 Hz default setting
2:60 Hz default setting
3:Factory default setting
4:Trip clear
5:Cumulative operation time cleared
6:Initialization of type information
7:Save user-defined parameters
8:Reset of user-defined parameters
9:Cumulative fan operation time record clear
10:Acceleration/deceleration time setting 0.01
sec.~600.0 sec. *1
11:Acceleration/deceleration time setting 0.1
sec.~6000sec.
1/1 0 Disabled ●/● ● ● 5. 20
0050
Registered parameter display
selection
0:Standard setting mode at turn on the power
1:Quick mode at turn on the power
2:Quick mode only
1/1 0 Enabled ●/● ● ● 5. 22
~
- Extended parameters Set detailed parameters shown in the following pages. - - - ●/● ● ● -
- Automatic edit function - - - ●/● ● ● 4. 2
*1: If is set to , the optional communication devices DEV002Z, PDP002Z, MTS001Z, APG001Z, LIU006Z, BCN001Z, IPE001Z and CCL001Z cannot be used with the inverter. (The
personal computer communications software PCM001Z cannot be used, either.) Furthermore, the copy function of the LED extended panel option (RKP002Z) does not work normally, so use
only the parameter setting function and the monitoring function.
*2: Default values vary depending on the capacity. See the table of K-42.
To Next Page
Loading...
Need help?
General
