SPAA-214-R1
TABLE OF CONTENTS
Page
1. UNPACING ---------------------------------------------------------------------------------------------1- 1
1.1 PROCEDURE ---------------------------------------------------------------------------------------------1- 1
1.2 CHECKS ----------------------------------------------------------------------------------------------------1- 1
1.3 POWER CORD -------------------------------------------------------------------------------------------1- 2
2. INSTALLATION PROCEDURE -------------------------------------------------------------------2- 1
2.1 CONNECTING THE TRST-A10 TO THE POS TERMINAL -----------------------------------2- 1
2.2 CONNECTING THE DRAWER -----------------------------------------------------------------------2- 3
3. DISASSEMBLY AND REASSEMBLY -----------------------------------------------------------3- 1
3.1 MAINTENANCE TOOLS --------------------------------------------------------------------------------3- 1
3.2 DISASSEMBLING THE MAIN BODY ---------------------------------------------------------------3- 2
3.2.1 Removing the Receipt Cover --------------------------------------------------------------------3- 2
3.2.2
Removing the Cover Top --------------------------------------------------------------------------3- 5
3.2.3
Removing the Interface Card --------------------------------------------------------------------3- 7
3.2.4
Removing the PCB ----------------------------------------------------------------------------------3- 8
3.2.5
Removing the Print Block -------------------------------------------------------------------------3- 9
3.2.6
Removing the Paper Low Sensor -------------------------------------------------------------3-12
3.2.7 Removing the Top Frame Block ------------------------------------------------------------- 3-12
3.2.8 Disassembling the Bottom Frame -------------------------------------------------------------3-14
3.3 REASSEMBLE PROCEDURE ----------------------------------------------------------------------- 3-15
4. DIP SWITCH FUNCTION ---------------------------------------------------------------------------4- 1
4.1 DIP SWITCH SETTINGS -------------------------------------------------------------------------------4- 1
4.2 DATASCOPE MODE ------------------------------------------------------------------------------------4- 2
5. SELF TEST PRINT -----------------------------------------------------------------------------------5- 1
5.1 SELF TEST ------------------------------------------------------------------------------------------------5- 1
5.2 ROLLING ASCII PRINT TEST (RECEIPT) --------------------------------------------------------5- 2
5.3 H PRINT TEST (RECEIPT) ----------------------------------------------------------------------------5- 3
5.4 DUTY CHECK PRINT TEST ---------------------------------------------------------------------------5- 4
5.5 PRINT CURRENT SETTING --------------------------------------------------------------------------5- 5
6. TROUBLE SHOOTING ------------------------------------------------------------------------------6- 1
6.1 TROUBLESHOOTING PROCEDURE --------------------------------------------------------------6- 1
6.2 TROUBLESHOOTING GUIDE ------------------------------------------------------------------------6- 1
7. PERIODIC MAINTENANCE ------------------------------------------------------------------------7- 1
7.1 PERIODIC MAINTENANCE PROCEDURE -------------------------------------------------------7- 1
CAUTION!
1. This manual may not be copied in whole or in part without prior written permission of TOSHIBA
TEC.
2. The contents of this manual may be changed without notification.
3. Please refer to your local Authorised Service representative with regard to any queries you ma
To Next Page
Loading...
