K-21
E6581386
11
[25] Operation panel parameters [1/3] Sensorless vector/vector with sensor (●:Effective, -:Ineffective)
Title
Communi
cation
No.
Function Adjustment range
Minimum
setting unit
(Panel/Communi
cation)
Default
setting
Write during
running
Vector
control
PM
control
V/f Constant
Reference
0700 Parameter write protect selection
0:Permit
1:Prohibit
1/1 0 Enabled ●/●●●6. 31. 1
0701 Current/voltage unit selection
0:%
1:A (ampere)/V (volt)
1/1 0 Enabled ●/● ● ● 5. 15
0702 Frequency free unit display magnification 0.00:OFF, 0.01~200.0 0.01/0.01 0.00 Enabled ●/●●●6. 31. 2
0703 Frequency free unit conversion selection
0:All frequencies display free unit conversion
1:PID frequencies free unit conversion
1/1 0 Enabled ●/●●●6. 31. 2
0705 Free unit display gradient characteristic
0:Negative inclination (downward slope)
1:Positive inclination (upward slope)
1/1 １ Enabled ●/●●●6. 31. 2
0706 Free unit display bias 0.00~ Hz 0.01/0.01 0.00 Enabled ●/●●●6. 31. 2
0707 Changing step selection 1 0.00:Disabled, 0.01~ Hz 0.01/0.01 0.00 Enabled ●/●●●6. 31. 3
0708 Changing step selection 2 0:Disabled, 1~255 1/1 0 Enabled ●/●●●6. 31. 3
0709 Standard monitor hold function
0:Real time
1:Peak hold
2:Minimum hold
1/1 0 Enabled ●/●●●8. 3
0710 Standard monitor display selection 0~73 *1 1/1 0 Enabled ●/●●●8. 3
0711 Status monitor 1 display selection Ditto 1/1 1 Enabled ●/●●●8. 3
0712 Status monitor 2 display selection Ditto 1/1 2 Enabled ●/●●●8. 3
0713 Status monitor 3 display selection Ditto 1/1 3 Enabled ●/●●●8. 3
0714 Status monitor 4 display selection Ditto 1/1 4 Enabled ●/●●●8. 3
0721 Operation panel stop pattern selection
0:Deceleration stop
1:Coast stop
1/1 0 Enabled ●/●●●6. 31. 5
0730
Operation panel frequency setting
prohibition selection
0:Permit
1:Prohibit
1/1 0 Enabled ●/●●●6. 31. 1
0734
Operation panel emergency stop operation
prohibition selection
0:Permit
1:Prohibit
1/1 0 Enabled ●/●●●6. 31. 1
0735
Operation panel reset operation prohibition
selection
0:Permit
1:Prohibit
1/1 0 Enabled ●/●●●6. 31. 1
0736
Prohibition of change of /
during operation
0:Permit
1:Prohibit
1/1 1 Enabled ●/●●●6. 31. 1
0737 All key operation prohibition
0:Permit
1:Prohibit
1/1 0 Enabled ●/●●●6. 31. 1
This parameter moves to a fundamental parameter.
*1: ⇒ For the adjustment range, see the table on page K-34.
To Next Page
Loading...
