Toshiba VF-PS1 - Setting Frequency Command Characteristics; Preset Speed Operation (Speeds in 15 Steps

E6581386
E-18
5
5.11 Setting frequency command characteristics
 ~  ,  : VI/II point setting

~  ,  : RR/S4 point setting

~  : RX point setting

~  :

~  :

~  :

~  : Point 1, 2 setting/ frequency
⇒ For details, refer to Section 7.3.
5.12 Preset speed operation (speeds in 15 steps)
 ~  : Preset speed operation frequencies 1~7

~  : Preset speed operation frequencies 8~15
[Setting methods]
1)Run/stop
Run and stop control is experienced by the operation panel (Default setting).
Title Function Adjustment range Example of setting

Command mode
selection
: Terminal input enabled
: Operation panel input enabled (including
LED/LCD option input)
: 2-wire RS485 communication input
: 4-wire RS485 communication input
: Communication option input

Note 1: If speed commands (analog signal or digital input) are switched in line with preset speed operations, select the
terminal board using the frequency setting mode selection 1 .
⇒ Refer to 3) or Section 5.5.
2)Preset speed frequency setting
Set the speed (frequency) of the number of steps necessary.
Setting from speed 1 to speed 7
Title Function Adjustment range Default setting
~
Preset speed operation
frequencies 1~7
~ 
Setting from speed 8 to speed 15
Title Function Adjustment range Default setting
~
Preset speed operation
frequencies 8~15
~ 
It sets up, when using the optional circuit board.
• Function
A maximum of 15 speed steps can be selected just by switching an external contact signal. Preset speed
frequencies can be programmed anywhere from the lower limit frequency  to the upper limit frequency .
• Function
These parameters adjust the output frequency according to the externally applied analog signal (0~10Vdc
voltage, 4(0)~20mAdc current) and the entered command for setting an external contact frequency.