27
Chapter 6
Bandwidth Control
2. Enter a range of IP addresses and port numbers to be controlled.
IP Range: The IP range can be a single IP address or IP address range according to
your needs. If you set the IP Range to a single IP address, the computer with this
IP address will get independent given bandwidth. If you set the IP Range to an IP
address range, all computers in the range will share the given bandwidth.
Port Range: Enter a range of port numbers to be controlled.
3. Select the protocol type for this rule.
4. Select a priority level for this rule. 1 is the highest priority level and 8 is the lowest
priority level. The total upload and download bandwidth will be allocated to guarantee
the minimal rate of all bandwidth control rules.
5. Enter the minimum and maximum upload bandwidth and download bandwidth
through the WAN port.
6. Select the Enable This Entry check box.
7. Click Save to make the settings effective.
To Next Page
Loading...
