TP-Link JetStream T1500G-10MPS - Page 19

Name
Status
Indication
PoE MAX
On
The remaining PoE power≤7W
Flashing
The remaining PoE power keeps ≤7W after this LED is
on for 2 minutes.
Off
The remaining PoE power>7W
Speed or
PoE
Green
On
The port is supplying power normally.
Flashing
The supply power exceeds the corresponding port's
maximum power.
Yellow
On
Overload or short circuit is detected.
Flashing
Power-on self-test has failed.
Off
No device is connected to the corresponding port.
SPF1, SFP2
Green
On
A 1000Mbps device is connected to the
corresponding port, but no activity.
Flashing
Data is being transmitted or received.
Yellow
On
A 100Mbps device is connected to the corresponding
port, but no activity.
Flashing
Data is being transmitted or received.
Off
No device is connected to the corresponding port.
 Reset
Press this button for five seconds or above to reset the software setting back to factory default
setting.
 10/100/1000Mbps RJ45 Port and PoE Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each
has a corresponding Speed or PoE LED.
 SFP Port
Designed to install the SFP module. T1500G-10MPS features 2 SFP transceiver ports.
 T1500G-8T
The front panel of T1500G-8T is shown as Figure 2-2.
Figure 2-2 Front Panel of
T1500G-8T
9