TP-Link JetStream TL-SG3424P - Chapter 19 System Commands; System-Descript; System-Time Gmt

96
Chapter 19 System Commands
System Commands can be used to configure the System information and System IP, reboot and
reset the switch, upgrade the switch system and other operations.
system-descript
Description
The system-descript command is used to configure the Device Name, Device
Location and System Contact. To clear all the information, please use no
system-descript command.
Syntax
system-descript { sysname {sysname} | location {location} | contact-info
{contact_info} }
no system-descript {sysname | location | contact_info}
Parameter
sysname —— System Name(Device Name). The length of the name ranges
from 1 to 32 characters. By default, it is empty.
location —— Device Location. It consists of 32 characters at most. By default,
it is empty.
contact_info —— Contact Information. It consists of 32 characters at most. By
default, it is empty.
Command Mode
Global Configuration Mode
Example
Configure the System Contact as www.tp-link.com.cn:
TP-LINK(config)# system-descript contact-info www.tp-link.com.cn
system-time gmt
Description
The system-time gmt command is used to configure the time zone and the IP
Address for the NTP Server. To clear all the information, please use no
system-time gmt command.
Syntax