TP-Link JetStream TL-SG3424P - Lldp Med-Tlv-Select; Lldp Med-Location

195
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the LLDP-MED status for port 6:
TP-LINK(config)# interface ethernet 6
TP-LINK(config-if)# lldp med-status enable
lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp med-tlv-select
command. By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp med-tlv-select [inventory-management] [location] [network-policy]
[power-management] [all]
no lldp med-tlv-select [inventory-management] [location] [network-policy]
[power-management] [all]
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Exclude “network policy” and “inventory” TLVs in LLDPDU outgoing from port 8:
TP-LINK(config)# interface ethernet 8
TP-LINK(config-if)# no lldp tlv-select network-policy inventory-management
lldp med-location
Description
The lldp med-location command is used to configure the Location Identification
TLV's content in outgoing LLDPDU of the port.
Syntax
lldp med-location {emergency-number identifier| civic-address [language
language | province-state province-state | county county | city city | street street|
house-number house-number | name name | postal-zipcode postal-zipcode |
room-number room-number | post-office-box post-office-box | additional
additional| country-code country-code | what what]}