TP-Link JetStream TL-SG3424P Cli Reference Guide

17
TP-LINK(config-if)#description vlan2
switchport type
Description
The switchport type command is used to configure the Link Types for the
ports.
Syntax
switchport type { access | trunk | general }
Parameter
access | trunk | general —— Link Types. There are three Link Types for the
ports.
Command Mode
Interface Configuration Mode ( interface ethernet / interface range ethernet )
Example
Specify the Link Type of port 5 as general:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)#switchport type general
switchport allowed vlan
Description
The switchport allowed vlan command is used to add the desired port to IEEE
802.1Q VLAN,or to remove a port from the corresponding VLAN.
Syntax
switchport allowed vlan add vlan-list
switchport allowed vlan remove vlan-list
Parameter
vlan-list —— VLAN ID list, it is multi-optional.
Command Mode
Interface Configuration Mode ( interface ethernet / interface range ethernet )
Example
Add port 2 to IEEE 802.1Q VLAN:
TP-LINK(config)# interface ethernet 2

TP-Link JetStream TL-SG3424P Specifications

General

Brand	TP-Link
Model	JetStream TL-SG3424P
Category	Switch
Language	English