40
Parameter
port-num —— The Ethernet port number. By default, display the configuration
information of all the Ethernet ports.
Command Mode
Any Configuration Mode
Example
Display the configuration information of all the Ethernet ports:
TP-LINK(config)# show lacp interface
show lacp system-priority
Description
The show lacp system-priority command is used to display the global system
priority value of LACP.
Syntax
show lacp system-priority
Command Mode
Any Configuration Mode
Example
Display the global system priority value of LACP:
TP-LINK(config)# show lacp system-priority
To Next Page
Loading...
